Power supply:220-240V, 50-60Hz;
Capacity: 4l. , distillation volume 1l. per hour, automatic switch-off at temperatures above 160C;
Method of use
1. Fill water into the body, not exceeding the mark (if you put warm water, the distillation time will be reduced);
2. Put the distiller tip back on the body and connect them both, with the cable coming from the tip plugged into the base of the body;
3. Put the bottle under the water drain hole on the top, and then plug into the power supply;
4. Press the start button located on the side of the body;
After about half an hour, distilled water begins to come out in the bottle. In 4 hours the still will make 4 litres of water.
Once the distillation is complete, the start button will turn itself off. On restarting the still temperature should have dropped below 70C, so wait a while. With several distillations one after another, remove the top for faster cooling – ~10min.
Cleaning
Clean the exterior of the still regularly.
Use clean water to remove dirt deposits after each distillation cycle.
Every month clean with the applied powder by pouring the water just above the bottom, put 1 scoop of the powder, connect to the power and start without covering with the top and after ~15-30min. wash the inside using clean water.
Clean and regularly and outlet filter and replace as necessary.